Thanks for reply.

I bought this Access point a week ago

http://www.trademe.co.nz/structure/a...sp?id=37177979

It is a Intel PRO Wireless 2011 LAN Acess Point

Ex owener says he has been using it with his XP.

There is a S/N at the back with a barcode that says:

000347144EC3

I was going to telnet to it assuming that is an IP address according to
Intel®PRO/Wireless 2011 -Access Point
Product Reference Guide
It says
"Section:Gaining Access to the UI
The method for establishing access to the UI depends on the connection
used. Select the setup that best fits the network environment.

"2.1.1 Using a Telnet session to gain access to the UI requires that a
remote station have a TCP/IP stack. The remote station can be on the
wired or wireless LAN.
To access the AP from the workstation:
1. From the DOS prompt Telnet to the AP using its IP address:
Telnet xxx.xxx.xxx.xxx
2. At the prompt type the password:
Intel
The password is case-sensitive."

but I think that is shorter than an IP address to be telneted...
there is WLAN Utilities in intels website that I have downloaded but
WLan Monitor application says 'An Intel(R) PRO/wirless 2011 LAN adaptor
not found'


Thanks .