Woggle pretended :
> Thanks for the note -
>
> I'm using Firmware software version 3.1.10 (Gwd) and hardware version
> 2.0.1(9472)
>
> So are you saying this doesn't work with UK Caller ID or is it that I
> need to change -
>
> PSTN Answer Delay to something like 16
>
> and
>
> PSTN Ring Thru Delay to something like 5
>
> so the SPA recognises Caller ID??
>
> (although that is based on US numbers).
>
> If it will never recognise it, I guess the only way around it then
> would be to leave it blank so that everyone gets the Voip line.
>
> That is quite annoying given that I would want the answerphone to pick
> up any messages and it wouldn't be able to under this way.
>
> Mark
>
>
>
> Jono wrote:
>> "Woggle" <markgolledge@googlemail.com> wrote in message
>> news:1155472558.114346.286980@i3g2000cwc.googlegro ups.com...
>>> I'm trying to set the SPA 3000 so I can call in from my mobile number
>>> and then receive a dial tone and dial out through Voip.
>>>
>>> Unfortunately the SPA doesn't recognise my mobile number. If I leave
>>> both PSTN Caller ID Pattern and PSTN Access List blank then it works
>>> for any number but I want to restrict this just to my mobile.
>>>
>>> Settings are as follows:
>>>
>>> PSTN-To-Voip Gateway Setup: Yes
>>> PSTN Caller Auth Method: Yes
>>> PSTN Ring Thru Line 1: Yes
>>> PSTN PIN Max Retry:
>>> PSTN CID for Voip CID: Yes
>>> PSTN CID Number Prefix:
>>> PSTN Caller Default DP: 1
>>> Off Hook while calling Voip: No
>>> Line 1 signal hook flash to PSTN: Disabled
>>> PSTN CID Name Prefix:
>>> PSTN Caller ID Patter: (just enter my mobile number starting 07)
>>> PSTN Access List: (just enter my mobile number starting 07)
>>> PSTN Caller 1 PIN: 1234
>>> PSTN Caller DP: 1
>>>
>>> PSTN Answer Delay: 5
>>> PSTN PIN Digit Timeout: 10
>>>
>>> As for CID - I'm currently in the UK and it is set to (under Regional
>>> Tab) ETSI FSK with PR (UK)
>>>
>>> Caller ID FSK Standard is set to bell 2002
>>>
>>>
>>> On info page, last PSTN caller comes up as , 07 (i.e. my mobile number)
>>>
>>>
>>>
>>> Thanks
>>
>> What firmware are you using?
>>
>> From their FAQ: "NOTE: SPA-3000 only supports Bellcore Type I (On-Hook)
>> Caller ID." (which may only refer to the Access List & Pattern list)
>> http://www.sipura.com/support/spa300...ction_4.html#1
>>
>> AFAIR, I had exactly the problem you describe & came to the conclusion that
>> it doesn't function on UK callerID

I'm saying........"I could never get it to work"

I will be watching this thread in the hope that someone else /has/ got
it to work.