David wrote:

> "When set to "Access Point Client", "Wireless Bridge" or "Wireless
> Bridge - Point to MultiPoint" mode, the device will only communicate
> with another WAP 11 ver. 2.6,WAP 11,WAP54G,WAP55AG,WRT54G or WRT55AG."
>
> This is in the setup of my WAP11


This is what my WAP11 says too on the main setup page. But try as I
may, entering MAC addresses, I cannot get it to act as a client or
repeater for my WRT54G.

Is there anybody out there that has had success bridging or using the
WAP11 as a client?