"Wim" <post@nospamraketnet.nl> hath wroth:

>I connected another powersupply (6V instead of 5V) and is working again!
>With 5V it consumes 270mA en with 6V 450mA.
>It seems the build in power regulator has a increased voltage drop.

The wall wart on a WAP11 ver 2.2, in my pile of junk, shows 5V 2.0A.

Your 5V at 0.27A = 1.4 watts. That is far too low for a typical
WAP11. I'll measure the current drain later today but my guess(tm) is
about 5-7 watts consumption. Something is wrong. Are you sure your
5V wall wart is putting out about 5VDC? The 5V switchers are not
known for their reliability. However, when they fail, they usually go
to zero volts output, so that's probably not the problem.

--
Jeff Liebermann jeffl@comix.santa-cruz.ca.us
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558