11-24-2006, 07:47 PM
|
| |
 Re: Wireless between two Buffalo WHR-G54S
Bridge Install http://www.dd-wrt.com/wiki/index.php/Bridge_Install
Louis Ohland wrote:
> http://www.dd-wrt.com/wiki/index.php/Wireless_Bridge
>
> This is what I'm looking for to the "T". Look at the "Practical Example"
> further down the page.
>
> I already pulled the WHR-G54S section out from the DD-WRT install page
> and am getting ready to PDF it. I see the bummer part on TFTP for the
> initial flash to DD-WRT, but subsequent flashes may be done with http.
>
> I think the boardflags were for the WHR-HP units only, and it was to
> enable the on-board amplifier.
>
> After a bit more surfing, I'll set up my ThinkPad 760XL (cutting edge!)
> to flash one of my WHR-G54S, that way my original one will still get me
> to the web if need be.
>
> Jeff Liebermann wrote:
>> Louis Ohland <ohland@charter.net> hath wroth:
>>
>>> Do tell about other than "stock firmware".
>>
>> See list at:
>> <http://en.wikipedia.org/wiki/Wrt54g#Third-party_firmware_projects>
>> I'm partial to DD-WRT and OpenWRT.
>> <http://en.wikipedia.org/wiki/DD-WRT>
>>
>> Installing DD-WRT on Buffalo products is a bit tricky as Buffalo
>> encrypts their firmware. See:
>> <http://www.dd-wrt.com/wiki/index.php/Installation#Buffalo_WHR-G54S.2C_WHR-HP-G54_and_WZR-RS-G54>
>>
>> You'll also need to do some "boardflags" tweaking to get it to work.
>>  |