I swapped it out with the Buffalo firmware WHR-G54S and here I am.

Louis Ohland wrote:
> Well, after a few miscues, it took.
>
> If you do a TFTP -i -v 192.168.11.1 PUT dd-wrt.v23_generic.bin, then you
> will see some boilerplate.
>
> Then when it starts to transfer, it will say:
> Packet will be sent. len=60, opcode=2
> Then it should say the identification of the block that is being sent.
>
> If you see this, it probably means that it's not taking, and will fail.
> Packet will be sent. len=60, opcode=2
> Packet will be sent. len=60, opcode=2
> Packet will be sent. len=60, opcode=2
> <repeats another 8 times>
>
> Now I have flashed it, ipconfig /all reports CONFIG2 as the server, I
> think, the port blinks, but no joy at 192.168.11.1
>
> Perhaps it's due to not logging in under W98SE (kiddie OS)? I'll swap it
> out with the one on the cable modem.