I had to check with IPCONFIG /ALL to figure out that I should be using
192.168.1.1 to talk to my WHR-G54S.

Splash screen for DD-WRT is much better than the Buffalo one.

Louis Ohland wrote:
> But I cannot connect with the WHR-G54S internal page. 192.168.11.1 times
> out.
>
> Is there a way to see the IPs in a subnet?
>
> Louis Ohland wrote:
>> I swapped it out with the Buffalo firmware WHR-G54S and here I am.
>>
>> Louis Ohland wrote:
>>> Well, after a few miscues, it took.
>>>
>>> If you do a TFTP -i -v 192.168.11.1 PUT dd-wrt.v23_generic.bin, then
>>> you will see some boilerplate.
>>>
>>> Then when it starts to transfer, it will say:
>>> Packet will be sent. len=60, opcode=2
>>> Then it should say the identification of the block that is being sent.
>>>
>>> If you see this, it probably means that it's not taking, and will fail.
>>> Packet will be sent. len=60, opcode=2
>>> Packet will be sent. len=60, opcode=2
>>> Packet will be sent. len=60, opcode=2
>>> <repeats another 8 times>
>>>
>>> Now I have flashed it, ipconfig /all reports CONFIG2 as the server, I
>>> think, the port blinks, but no joy at 192.168.11.1
>>>
>>> Perhaps it's due to not logging in under W98SE (kiddie OS)? I'll swap
>>> it out with the one on the cable modem.