Hi: I have two Panasonic BL-C30A internet cameras installed in a 2nd
home in another state. I was able to access them remotely (being at my
1st home). Both cameras could not be displayed at once under
multi-cameras, but I could access them properly through using their
Global Addresses and port numbers ( each having a diff. port number). I
decided to tinker with the settings remotely - that was dumb. I
remembered that I had my Netgear WGR614v6 router set with WEP (64 bit
and using 1 key). So, foolishly, I decided that I would go into
Panasonic Setup online ( thru the router), and changed the WEP settings
fron none to the exact ones matching the Netgear router. After I did
this, I could never access camera 1 (used to check a host of imp. items
like house temperature) again. Camera 2 (my lest important one) worked
properly, but would display where camera 1 was previously. I never
could get things corrected and eventually lost camera 2, by tampering
with the "automatic setup" , when I had been using "static setup."
Problem: Now I can't access either Global Address, and I do use their
respective port numbers ( 80 aand 81 ). Lastly, Viewnetcam.com will not
take me anywhere ( get no page thingy), so I'm really stuck. I can
access my router remotely and change router settings ( they are all
correct), but I cannot access the cameras. Any ideas or solutions would
be greatly appreciated. If I could just get the Panasonic Setup program
up and running that would be helpful, but now I can't do this either. I
think when I tinked with the "automatic setup" it did me in. It's a
very long drive for me to travel to the 2nd home from here. Hoping
there is another solution that can be done remotely.
Again, all suggestions are welcomed. You may email me as well as
leaving message here.
Thanls, Gibby