View Single Post
  #5 (permalink)  
Old 02-01-2007, 09:03 PM
kony
Guest
 
Posts: n/a
Default Re: Unstable Machines

On Thu, 01 Feb 2007 18:31:00 GMT, Jethro
<Wilson@somewhere.org> wrote:


>They are both plugged into the same surge protector - thence the same
>wall socket. Might should by-pass the surge protector?


I doubt that's it, but might as well remove it from the
equation for the time being, doing so could only help to
isolate variables.

>I have a
>whole-house protector outside anyway. You see, I was hit with a
>destructive surge twice (a year apart) about four years ago - before
>these machines.
>
>Say - Do you think that leaving my cases open might hurt cooling by
>the fans? After all, there is not much circulation going on. I have
>measured temps though and they seem acceptable.



If you think there isn't enough airflow, improve that.
Whether an open case helps can depend on the case, with a
very bad case it can help a little but with a good setup it
should have minimal, sometimes even detrimental effect. You
might open it and temporarily point a desk fan at it, temp
sensors aren't *always* right.

Reply With Quote