View Single Post
  #3 (permalink)  
Old 02-18-2007, 03:57 PM
ChrisR
Guest
 
Posts: n/a
Default Re: WAG54G connection lost


"a" <me@privacy.net> wrote in message news:45D87C80.4090402@privacy.net...
> Since two laptops have both shown the fault together, it looks like it is
> a router problem rather than a PC or a PC firewall problem.
> Since wired connections work ok, it looks like IP addresses are allocated
> ok (and you get the same fault with static IP addresses).
>
> Was the problem present before the visitors PC showed up? Ie is it likely
> that the problem appeared as a result of changing the router configuration
> to get the visitor connected? If so then the router configuration looks
> to be the likely fault. If not then possibly the hardware has failed, or
> needs resetting back to the factory settings.


There were no changes to the router configuration for the visitor. I have
been periodically blocking internet access for the laptops on the router (to
get boys to do homework) but taht shouldn't affect connection to the LAN,
and it's off now.

> Things to check:-
> In the Router Configuration web page:-
>
> 1. under router Wireless.BasicWirelessSettings
> 1.1 - is the wireless Network Mode compatible with what your laptops
> are using? (ie 802.11b, 802.11g, or Mixed?)


G-only

> 1.2 - is the SSID the same as which your laptops are trying toconnect
> to?


Yes. SSID broadcast is on and the laptops see it and attempt to connect to
it, but fail.
>
> 2. under Wireless.WirelessNetworkAccess :-
> 2.1 Is it set to AllowAll? (or if not, do the MAC addresses match up
> ok?)


Yes, allow all
>
> 3. Under Wirless.AdvancedWireless:-
> 3.1 Is AP Isolation set to OFF?


Can't see such a setting
>
> 4. If these all look ok, does it work when the laptops are close to the
> router? If so then this might imply interference or poor signal strength
> to your usual operating locations.


Tried that, makes no difference, also tried changing channel
>
> 5. If all else fails, you could try resetting the router to its factory
> settings, and re-entereing the ISP connection and wireless parameters .
> Make sure you make a note of these before you reset your router, as you'll
> need to re-enter them.
> In particular, make sure that you have your userid and password,
> Encapsulation, VCI and VPI parameters noted down before you start,


Yes, may have to try this or even reinstall firmware. Come to think of it I
have also been having problems with VPN which might point to a router
problem.
>
> C
>

Thanks for your help C.

>
> ChrisR wrote:
>> My sons have identically-configured laptops running XP. We have a Linksys
>> WAG54G v2 wireless gateway which has worked fine until recently. Now
>> neither PC can connect wirelessly, though wired connections to the router
>> work fine.
>>
>> XP can see the network and attempts to connect to it automatically, but
>> fails - either with a long "waiting for the network" or "obtaining
>> network address". A visitor's PC had the same problem.
>>
>> I have tried:
>> - rebooting the router
>> - disabling WPA-PSK security
>> - changing frequency, in case of interference
>> - disabling the firewalls on the PC's (Zonealarm)
>> - bringing the PC's into the same room as the router to ensure a strong
>> signal
>> - running the XP "repair connection" tool - just says it cannot connect
>> and to contact the network administrator (I guess that's me)
>> - setting a static IP for the PC's (normally use DHCP)
>> all to no avail.
>>
>> I don't think any settings have changed or anything relevant is likely to
>> have been installed; I did install a dial-up network connection on the
>> PC's for use when away from home, but it isn't attempting to dial.
>>
>> Any suggestions please?
>>
>> Chris R




Reply With Quote