linksys wireless router BEFW11s4 v3

Hello: I was trying to upgrade the firmware. Now the diag lite is
constantly on (not blinking). I tried everything, resetting for 30
sec, 3 min etc, trying to upload firmware again, static ip address
etc. but my computer can not communicate to the router...so I can't do
anything..is this a dead router?

btw i called linksys tech support guys and they told me that they
could fix the problem remotely but would charge me $29.95..So i got
the impression that there should be a solution to fix it but what is
it really?

any help is MUCH appreciated folks.
Cheers

On Sep 5, 1:16 pm, Zorluhan Zorlu <zorlu...@gmail.com> wrote:
> Hello: I was trying to upgrade the firmware. Now the diag lite is
> constantly on (not blinking). I tried everything, resetting for 30
> sec, 3 min etc, trying to upload firmware again, static ip address
> etc. but my computer can not communicate to the router...so I can't do
> anything..is this a dead router?
>
> btw i called linksys tech support guys and they told me that they
> could fix the problem remotely but would charge me $29.95..So i got
> the impression that there should be a solution to fix it but what is
> it really?
>
> any help is MUCH appreciated folks.
> Cheers

Dunno specifics of that box, but first thing I'd try:
assume AP's IP set back to default; configure pc's nic
to use address in that range (full IP to suit), and run
cat-5 between pc and AP's bridge port (ethernet.)
Then proceed.

HTH,
J