Is there a way to use the d-link DWL-G122 rev C1 adapter *without*
using the D-Link user interface ? (ie : using only windows WZC ?)
I was successful two weeks ago in doing this with a DWL-G132 rev A,
grabbing the new drivers on d-link site and configuring WZC to access
my DI-624 using WPA2-PSK AES - even when SSID broadcast was turned off
without resorting to any d-link provided software.
Attempting the same with the DWL-G122 rev C (3.10 driver) on a newly
installed XP-Pro system (with kb917021 installed) fails.. It won't
find non broadcast SSIDs, won't reconnect automatically on reboot and
will even fail to connect to my neighbourg's unprotected AP.
Running the setup which come with the driver installs the D-Link Air
Plus Utility as well as ANIO and ANIWZCS2 services, and make it work
correctly.
The DWL-G132 had the same 3 elements installed. I just uninstalled
them, installed KB917021, inserted the USB adapter, pointed to the
driver's location and everything work fine since then..
While I understand the adapters chipsets and drivers are not the same,
I'm wondering why it works flawlessy in one case but not at all in the
other one.
Problem using WZC with a d-link USB wifi adapter. 
Linear Mode
