Filo_Flame wrote:
> Hi folks !
>
> I have an Ubiquiti Super Range Card and I wanna use it under Linux
> System.. so I've downloaded MadWifi NG, Madwifi was succesfully
> installed.
> Card is detected as "ath0"..but when I perform a "iwlist ath0 scan" the
> result is "no scan result" in every case..and I've noticed that Tx/Rx
> Power is set to 0 !
> So...I've downloaded Madwifi Old Version and in this case the card
> seems to work but with less less power than effective power (300 mw).
> Do you know what could be the problem?
Did you take into account the "power offset"?
http://www.ubnt.com/downloads/SRXR_power_offset.pdf
>
> I use a PowerBook G4 with Slackintosh 12.0 .
>
> Thanks
>
> Ciao
>
>
> ------------------------------------------------------------------------
> View this thread: http://www.wirelessforums.org/troubleshooting/ubiquiti-src-madwifi-33440.html
> http://www.wirelessforums.org
>
Re: Ubiquiti SRC & MadWifi 
Linear Mode
