to set up power transmission of AP

hello to all,
I have a Pci card with chip Prism2 installed on a mother board for
device embedded, have installed the hostAP driver in order to make it
to work as AP... but I would have needs it to control and to manipulate
via software and in realtime the power of transmission in dB... someone
knows to say me if it is possible to make it and if some software
exists already eventually to adapt

thanks, Salvo

The transmission power will be controlled by the chip that your using. You
might need an amplifier if that doesn't work.

Doug

"salvodi" <salvodi@gmail.com> wrote in message
news:1175186923.997698.265930@l77g2000hsb.googlegr oups.com...
> hello to all,
> I have a Pci card with chip Prism2 installed on a mother board for
> device embedded, have installed the hostAP driver in order to make it
> to work as AP... but I would have needs it to control and to manipulate
> via software and in realtime the power of transmission in dB... someone
> knows to say me if it is possible to make it and if some software
> exists already eventually to adapt
>
> thanks, Salvo
>