DLW-2100AP and DHCP server

Using DLW-2100AP as WAP and would like to use the builtin DHCP server

But for the life of me I have been unable to figure out what is supposed to go in at least two lines of the config on the DLW-2100AP DHCP configuration page. Included in the linked screen grab below and the attached image.

[The tiny image may be too small to actually see but is all this forum will allow me.

Further, the forum would not allow me to post a link unless I'd posted at least 5 messages so couldn't to that either]

I've managed to slip a link with a reasonably sized image past the censorship by inserting ` DOT ' in place of periods, just in case you want a better look, remove the ` DOT ' and insert `.' to make a usable link:

www DOT jtan DOT com/~reader/vu/disp.cgi

And in Text below:
--------------------------
Ip assigned from [ ]
Range of pool [ ]
--------------------------

I've put every number or numbers that seemed feasible but always it gets rejected and will not complete.

My home lan network is 192.168.0.0/24
I've tried putting this: 192.168.0.1
in the first slot. Which seems to be accepted

For DHCP assignments I'd like a range of 192.168.0.60 thru
192.168.0.70 (11 possible addresses)

So for the second slot I've tried:
11
or
60-70

And a few more combinations I don't even remember now, but each time the config is rejected on the `Range of pool' line.

Can anyone tell me what is expected there?

Aside:
Subnetmask and gateway:
255.255.255.0 and 192.168.0.20 respectively
In case it helps.

Attached Images

 

you should put the address ranges there that your client will get from this AP when they want to connect it.