| ||LinkBack||Thread Tools||Display Modes|
New wireless router installation
I installed a new router WRT300N.
Enabled WEP, with a passphrase and generated the security.
When i connect, it prompts for passphrase/security key.
It accepts only with the security key and not the passphrase.
For new connections I would need to copy the security key that was generated.
How can I make it accept the passphrase that was used?
Are you positive the device is brand new and is not a refurb that has been previously used and pawned off to you? If it is a refurb, someone may have used it prior to you with different security settings. Did the packaging look brand new? etc.
Assuming the brand of that device is Linksys - try this solution:
Run ipconfig/renew and at the command line try your password again and it may work.
Failing that, let me know and I will try to help you.
Regards - Mark
|Thread||Thread Starter||Forum||Replies||Last Post|
|Re: Wireless Router Can't See Wireless Device||ohaya||alt.internet.wireless||4||08-05-2009 04:40 AM|
|Wireless router is no longer a router?||Ikke||alt.internet.wireless||7||02-01-2007 11:23 PM|