I was told by Netgear to upgrade my firmware to improve signal strength. I had to go from 4.2.4_1.0.1, incrementally to 4.2.11_1.0.1. The problem is when uploading the first upgrade, ie 4.2.6_1.0.1, what should have taken about one minute was still "going" after half an hour. I kiiled the upload and now it won't boot at all. The lights go on but the power light cycle between green and orange every couple of seconds. I've tried the reset button.
I'm guessing the firmware is corrupted so I need to flash the memory again with a new (or old) version.
Amyone know if I can do this, and if so how? Or any other thoughts on a fix to this god awful problem?
Netgear WGT624 won't boot 
Linear Mode
