Problems with Cisco 1121 AP - Radio changes state to reset

I'm fairly new to wireless networking on an enterprise level so bear with me. I've been working with Cisco 11xx series APs and one of the 1121's that I recently set up and shipped to a remote office is giving me the error

"Interface Dot11Radio0, changed state to reset"

It then proceeds to go into the "up" state. I'm working with someone to get them connected but that's a separate issue.

The other APs that I have are running the same version of the IOS so I don't see the need to upgrade just yet, so I was wondering a few things.

1. Is this a problem I should worry about? I don't have someone losing their connection yet so it's hard to tell what this is going to cause as far as problems in the near future.

2. If this is a problem I should worry about, what are some suggestions/fixes I should try?

This AP is now at a remote site so I can't go there and try to connect to the AP, so I have to wait for the indigenous personnel to be there when I'm in the office.

Thanks