Hello !
Intro:
Ok here's the deal.
My neighbor has internet spread over his house by wireless so I'm paying him to get internet too because no internet service reaches my house. He has set up the wireless antenna so I can get better signal, but I only get signal when I'm near the window.
So I bought a wireless access point which has repeater mode in it so I could expand the signal over my house too and use my laptop in other places aswell, not only near window.
Devices:
Mine: TP-LINK TL-WA501G
His: Linksys WRT54G
Problems:
1
First of all, when I try to connect to my AP, which hasn't been configured yet I get a message saying: Limited or no connectivity. I open wireless properties and manually set the internet protocol until it says: Connected.
Now i open default gateway and try to enable DHCP

What should i enter to these blanks ?
2
(May be fixed when all blanks in first problem are filled.)
Now when I have just set the AP to DHCP enabled without filling any blanks I open internet protocol again and change to automatic. Sometimes says connected sometimes limited.
So if I finally get connected I open default gateway again. I set the AP to repeater mode, click survey and choose right MAC. Reboot the AP and exit.
Now the icon on notification area shows that I'm connected to internet, but when I try to open any sites it says that I don't have connection.
Anyone know what may be the cause of it ?
Also:
Start>run>cmd>ipconfig /all (without my repeater)

Start>run>cmd>ipconfig /all (with my repeater)
Also notice that with repeater, theres no DNS Suffix
Hope someone can help me
Thx