Re: SPA3000 config

Thanks, Tim. That's great. Got it working now.

I wonder if you/anyone can advise me on a few points through please:

*When I pick up the phone at the SPA1001 end, there's 20 seconds of ringing
before the 3000 goes off-hook on the FXO port and I can hear the PBX dial
tone??

*In an incoming call scenario the 3000 actually picks up the call and then
forwards it to the 1001. As a result any other extensions ringing on that
incoming call stop ringing and cannot answer the call. Is it possible to get
the 3000 just to relay the ringing to the 1001 without picking up the call.
If the phone on the 1001 should then be picked up, then the 3000 can pick up
the call in turn?

*It doesn't seem possible to dial * and # codes once connected - they seem
to be picked up by the local ATA as commands(?). In the same vain, is it
possible to relay a recall across this solution for call transfer purposes
on the remote PBX?

Thanks,

Rupert


"Tim" <nutnews@kooky.org> wrote in message
news:44bbb38f$0$780$bed64819@news.gradwell.net...

> Specifically,
> http://www.provu.co.uk/pdf/sipura/sp...1x_spa1001.pdf
>
> Tim