Configuring Cisco 1300 Access Points for Point to Multipoint

Hi all,

<waves>

I'm a newbie here, and worse yet I'm a newcomer to wireless networking.

Can someone direct me to instructions or give me the instructions for

setting up a Cisco 1300 Series Access Point, for Point to Multipoint

configuration?

Hi , just to fill in the blanks...I'm trying to set up three Cisco bridges with one bridge communicating with the the two others, it should be very simple, but I'm not sure what is the settings etc for the bridge to pick up that it is not one but two it has to communicate with...

Dear i am i don't know about networking but i know little bit. let me tell you how to connect one access point to i mean point to point or multipoint.
you have to do two configuration. one for Root Bridge and 2nd is Remote Bridge.. in Cisco product you can't see these option .... in cisco Product you will see. Root Bridge and Non-Root Bridge. so let me tell you know how to configure it ...
you one Antenna will be Root Bridge. in Root Bridge you have to put other two Access poinr / Antenna Mac Address... and in the other Two Access point/ Antenna you have to put Root Bridge Mac address in Root Bridge option. Thanks for more information you can email me
Shahjs2002@yahoo.com