EAP-TTLS problem..

Hi All,
I am configuring wpa supplicant to use EAP-TTLS on wpa supplicant ported to marvell 8686. But have few raod block. Plz help me to solve the issue. luckily i am not getting any error in RADIUS server side...

1. Getting SSL connect error.

SSL: SSL_connect:before/connect initialization

SSL: (where=0x1001 ret=0x1)

SSL: SSL_connect:SSLv3 write client hello A

SSL: (where=0x1002 ret=0xffffffff)

SSL: SSL_connect:error in SSLv3 read server hello A

SSL: SSL_connect - want more data

SSL: 102 bytes pending from ssl_out

SSL: 102 bytes left to be sent out (of total 102 bytes)

EAP: method process -> ignore=FALSE methodState=MAY_CONT decision=FAIL



2. EAP entering failure state

EAP: EAP entering state FAILURE

CTRL-EVENT-EAP-FAILURE EAP authentication failed

EAPOL: SUPP_PAE entering state AUTHENTICATING

EAPOL: SUPP_BE entering state FAIL



my wpa_supplicant.conf as below

update_config=1

eapol_version=1

ap_scan=1

fast_reauth=1



network={

ssid="3Com"

scan_ssid=1

auth_alg=OPEN

proto=WPA

key_mgmt=WPA-EAP IEEE8021X

pairwise=TKIP CCMP

group=CCMP TKIP WEP104 WEP40

eap=TTLS

identity="jbibe"

anonymous_identity="jbibe"

password="whatever"

priority=2

phase2="auth=MD5"

}


-Raghu

Hi Raghu,

So wht does it mean by you dont get any error in the server side. Do you get successful authentication?? Or during the connection phase, if you do not get anything in the radius logs, then probably the authentication phase is not completeted and the eapol response does not reach the radius server. Wht radius server is in use? TTLS should use cert for the client as well as for the server.

Regards,
Kris

Any luck...is it working now???